Basic Set up Instructions
First, remove your new jellyfish aquarium from the box and inspect for any damages. Then place it on any aquarium stand with a solid top that supports the entire tank bottom. Fill with pre mixed saltwater, starting with the filter area on the right side of the tank opposite the Protein Skimmer. Add water to the lower area first until it is above the bottom of the circular viewing area. Then add water to the viewing area, then filter area again. You want to fill the viewing area and the filter area at the same rate. Fill to the top of the circular cut out on the front cover panel. Then attach wood air stone to rigid tubing using a short 1″ piece of flexible tubing. Put airline tube thru the center hole of the protein skimmer lid. attach flexible tubing to end of rigid tubing. Place air stone into the center tube of the protein skimmer and seat the lid into the skimmer cup. Run tubing over to the right side and thru the hole in the back of the tank. Connect to air pump, plug in air pump and circulate. Adjust water level for optimum protein skimmer performance. Level should usually be at the Red mark. Mount LED lighting to the lid. You are now ready to add jellyfish!